Troubleshooting Thread Pull-Outs on Embroidery Machines
Thread pull-outs can be frustrating, but most causes are simple to diagnose and fix. Below is a step-by-step guide to help you identify and resolve the issue. The most common...
Daniel Horgan
Help Centre
Troubleshooting Thread Pull-Outs on Embroidery Machines
-
How often should you change your embroidery machine needle?
This is a question that is frequently asked in the embroidery community. The sewing industry generally recommends changing needles every 6-8 hours of use. However, for multi-needle, multi-head machines, adhering...
Daniel Horgan
-
Mighty Hoops Hoop Field Size Information
Please use the information below to order your correct size of Mighty Hoop for your machine: BARUDAN EMBROIDERY MACHINES * If the model number starts with BED, BEV, BEX or...
Daniel Horgan
-
Threads are not trimming
Remove your needle plate to be able to fully inspect the knives. Under the needle plate you will find a silver articulating knife and a black knife that has SWF...
Daniel Horgan
-
Embroidery on Outdoor Workwear
Embroidery on Outdoor Workwear can be very difficult to frame up as these garments tend to be bulky and made from heavy fabrics. Standard plastic frames are ill-suited for this...
Daniel Horgan
-
All you need to know about our Generation 2 Ultra Soft Backing
Since its launch, Ultra Soft Tear Away backing has always been a top product here at ETC Supplies. We constantly take customer feedback on product quality and functionality to heart to ensure this...
Daniel Horgan
-
Clamp bulky items with the ICTCS3!
Do you have problems with clamping heavy bulky items such as Horse Blankets? Here is the solution! EMS RAIL Mounted Clamping System the ICTCS3 is the largest in the ICTCS...
Daniel Horgan
-
How to Embroider on College Kit
Great looking college kit is a must for any student! It is easy enough to start off with a good quality product and add some colourful embroidery. But how do...
Daniel Horgan
-
Sub-Moisture Issue
The introduction of moisture into the sublimation process can cause unwanted results. During production with a heat press operating at 200°C, moisture can flash to steam and literally blow the...
Daniel Horgan
-
Thread is frayed after it is cut
"I am experiencing thread breaks on most of the needles...not all the time just enough to be annoying. I noticed that the thread is frayed after it is cut. I...
Daniel Horgan
-
Thread Tension Gauge
The directions that come with your tension gauge tell you to test with the thread through the eye of the needle. I do know that lower, and more accurate readings...
Daniel Horgan
-
Why use toppings?
Why do Embroiderers use Topping? This is a very good question and one that is asked very frequently these days. The reason for using a Topping is to enable the...
Daniel Horgan
-
Too many sheets of backing?
Too many sheets of backing? "I need to use several sheets of embroidery backing on difficult embroideries and not only is it difficult to frame up - let alone tear...
Daniel Horgan
-
Sub-Road to Sublimation Success: Full Throttle
Without a doubt, the face of sublimation has changed dramatically over the last few years. We now have hundreds of new and exciting products including iPhone and iPad covers, SubliSLATE™,...
Daniel Horgan
